Health, Safety and Welfare for Construction and the Built Environment Essay - 1

Health, Safety and Welfare for Construction and the Built Environment - Assignment 2 - Essay utilisationWe also use information for the department of labour to ascertain if certain types of identified risks are baffleable as well as their chances of recurrence.When we have compiled the information about probable chances of hazards at the construction site, a decision is made based on this particular information. We also analyse the statistics of similar hazards identified or that have occurred in otherwise construction sites in order to come up with effective solutions to prevent them. The diagram below illustrates the methods we use to identify potential hazards at out construction site.The most cat valium hazards in either construction site include slips, trips and falls. These may cause both minor and gruelling injuries. Slips are common on wet surfaces while falls and trips butt occur at any stage of construction.Lifting crane is a commonly used for lifting building mater ial like bricks, cement, sand and other material. However, there is a risk that the items may fall which can cause injuries among the employees.Answer Standard formats for identifying and memorialize hazards on site are mainly used for presenting a solid basis upon which all hazards can be measured, interpreted as well as addressed. Our company has its own meter form of identifying and enter hazards.We mainly use this standard form to get feedback from the employees and supervisors. It provides all possible and probable hazards so golosh supervisors do not need to think a lot during questioning. He just needs to observe the standard form.Another very important use of the standard form is to compile data. If we dont have any standard form to identify hazard, collected data will be a mess. Finding out data from that mess will be very hard. By using the standard form, we can compile the data as our requirement. We just need to set the standard form in the desired format.By using s tandard form to identify and record hazards, we actually make this data